How much water to put in Baby Brezza Sterilizer

When using electrical appliances, basic safety precautions should always be followed, including the following:

1. Read all instructions carefully before using your sterilizer.
2. Ensure that the supply voltage marked on the appliance corresponds with your power supply.
3. If there is any visible damage to the appliance, the plug or to the supply cord, disconnect the appliance immediately and do not use it.
4. If the supply cord is damaged, it must be replaced by the distributor in order to avoid a hazard.
5. Do not allow children to touch or use the appliance. The appliance becomes very hot and the steam can cause severe scalding.
6. Do not move the appliance when it is in use or contains hot liquids.
7. Do not touch the hot surfaces.
8. Do not place the appliance on or near hot surfaces, in a heated oven or near a gas or electric heater.
9. Unplug the appliance from the power supply before cleaning or storage.
10. Do not immerse the supply cord, plug or base unit in water or any other liquid.
11. This appliance does not contain any user serviceable parts inside. Do not dismantle.
12. This appliance is for indoor household use only. Do not use outdoors.
13. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
14. This appliance has a polarized plug (one blade wider than the other). To reduce risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way.
15.  a) Short power-supply cord is provided to reduce the risks resulting from becoming entangled in or tripping over a longer cord.
    b) Extension cords are available and may be used if care is exercised in their use.
    c) If an extension cord is used: The marked electrical rating of the extension cord should be at least as great as the electrical rating of the appliance; The longer cord should be arranged so that it will not drape over the countertop or tabletop where it can be tripped over, snagged, or pulled on unintentionally (especially by children).
16. Children should be supervised to ensure that they do not play with the appliance.
17. Not for space heating purpose.
18. Always use on a level heat resistant surface.
19. Always keep the electric sterilizer and its plug out of reach of small children.
20. To disconnect, turn the control to “off”, then remove plug from wall outlet.
21. Ensure water has been added to the base unit before the sterilization cycle is switched on.
22. Always add 165ml/5.5oz of distilled water before use. If you put too little or too much water into the sterilizer, the sterilization efficiency may not be reached.
23. Always unplug from the electric outlet when not in use. Allow to cool before putting on or taking off any parts.
24.  Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner. Please contact the distributor’s Customer Service for more information.
25. The use of accessory attachments is not recommended by the appliance manufacturer as this may cause injuries.
26. This sterilizer is intended to be used in household and similar application such as a. staff kitchen areas in shops, offices and other working environments. b. farm houses. c. by clients in hotels, motels and other residential type of environments. d. bed and breakfast.
27. Do not open while in use as this product contains boiling water. Beware of escaping steam from the vent holes in the lid.
28. Allow at least 30 minutes interval between operations and make sure the unit has been cooled down before pressing the start button for sequential use.
29. Steam escaping from the unit can cause burns. Always allow 5 minutes to cool down after the cycle finishes before lifting the lid.
30. KEEP CHILDREN AWAY from this sterilizer at all times.
31. To provide continued protection against risk of electric shock, connect to properly grounded outlets only.
32. CAUTION: Risk of electric shock, disconnect electric power before servicing.
33. Use only distilled water, bottled water or fresh running water to sterilize.
34. Never use any additives.

Sterilizer Parts

TECHNICAL DATA
Supply voltage: 120V ~ 60Hz
Model: BRZ0070
Power: 750W

Set-up, Use and Cleaning

Before placing items in the appliance for sterilization it is important that all bottles, pump parts and accessories must be EMPTY, CLEAN & FULLY RINSED BEFORE USE in this sterilizer dryer.

1. Place the appliance on a flat surface where it is out of reach of children and it will not be knocked or moved during operation.
2. Remove the lid, baskets and accessory rack from the sterilizer base.
3. Pour distilled water on the base/heater surface to MAX line (165ml/5.5oz). Never fill past MAX line.
4. Place the lower basket on the base.
5. Place clean bottles with their opening facing downward on the bottle posts.
6. Place the accessory tray in the lower basket (tray not for use with tall bottles).
7. Place bottle accessories on the accessory rack (nipples, collars, caps, etc).
8. Place the upper basket on top of the lower basket, ensuring that it fits securely without any gaps.
9. Place breast pump parts or more accessories in the upper basket.
10. Press the power button once, the button will light up and the heater will turn on. When the sterilization cycle is done, the appliance will automatically turn off.

Cleaning

• Always unplug your product before cleaning.
• Do not immerse the base, the supply cord or the plug in water or other liquids.
• Do not clean base under water tap.
• Use a soft damp cloth to clean the base and control console.
• Never use abrasive pads to clean the plastic parts of the machine.
• The lid, accessory rack can be cleaned in hot soapy water.
• Mineral residue, particularly in hard water areas, may deposit on the stainless steel heating plate after a few sterilization cycles. To avoid scale build up, wipe the surfaces with a soft moist cloth after each operation.
• Deposits can be removed with scale removers or by leaving 60ml/2oz water and vinegar solution (50/50 water & vinegar mix) on the heating plate for approximately 30 minutes. The plate should then be wiped clean with a clean, dry cloth. Some discoloration spots may remain after cleaning with a vinegar solution, but these are harmless.
• Do not use abrasives or solvents for cleaning; they may damage the appliance and the surface of the heating plate.

Modular set-up options

Upper & Lower Baskets With Accessory Tray For use with short bottles, accessories & pump parts.Upper & Lower Baskets WITHOUT Accessory Tray For use with tall bottles, and accessories.Lower Basket only With Accessory Tray For use with short bottles, accessories & pump parts.Upper Basket only WITHOUT Accessory Tray For use with accessories pacifiers and small items.Breast pump parts and any other items safe for steam sterilization can be placed in the lower or upper baskets. Try different configurations to find what set-up works best for you.

Using the included tongs
The tongs can be inserted and stored in the upper basket or the accessory tray. When the tongs are clicked into place, they can be used to lift the basket or tray. Gently squeeze the tongs to remove them. They can also be used to grasp parts and bottle nipples in the sterilizer.

Troubleshooting

ConditionPossible CauseRemedyAppliance will not start.Unit is unplugged.Make sure the plug is securely inserted into the power outlet.Unit is not turned on.Press power button firmly until it lights up to start sterilization.Insuffi cient water is in heater plate area.Add 165ml/5.5oz water to heater plate area.Scaling on water tank heater plate.Mineral rich water used persistently.Clean heater plate after each use and use distilled water.

Limited 1-Year Warranty

The limited warranty is valid only on products bought through authorized resellers and used in Canada. Buying through an unauthorized reseller or using this product outside of Canada automatically voids this warranty. This warranty is available to consumers only. You are a consumer if you own a Baby Brezza® appliance that was purchased at retail for personal, family or household use. Except as otherwise required under applicable law, this warranty is not available to retailers or other commercial purchasers or owners. We warrant that your Baby Brezza® appliance will be free of defects in material or workmanship under normal home use for one year from the date of original purchase. Customer will be required to present original proof of purchase in order to obtain the warranty benefits. In the event that you do not have proof of purchase date, the purchase date for purposes of this warranty will be the date of manufacture. If your Baby Brezza® appliance should prove to be defective within the warranty period, we will repair it or, if we consider it necessary, replace it.

To obtain warranty services, please call Customer Service
at 1-800-667-8184 or write to: [email protected]

DISTRIBUTED BY: ELFE JUVENILE PRODUCTS 2520 AVE MARIE-CURIE SAINT-LAURENT (QC) H4S 1N1
[email protected] I www.elfe.com
1-800-667-8184
Please visit
babybrezza.ca
©2020 Baby Brezza Enterprises LLC

Documents / Resources

baby brezza BRZ0070 One Step Baby Sterilizer [pdf] Instructions
BRZ0070, One Step Baby Sterilizer

Related Posts

• Baby K’tan Baby Carrier Instruction Manual

  Baby K’tan Baby Carrier Instruction Manual - Original PDF Baby K’tan Baby Carrier Instruction Manual - Optimized PDF

• baby brezza smart soothing mat User Manual

  BabyBrezza® Smart Soothing Mat User Manual Check out our website - babybrezza.com for how-to videos, user guides, product…

• IKEA GULLIGAST Baby Gym Instruction Manual

  GULLIGAST CAUTION! The product is only suitable to be used on the floor. The baby gym can not…

• Baby Lock Walking Foot BLSA-WF Instructions

  SEWING ACCESSORIES Walking Foot (BLSA-WF) Instructions The Baby Lock Walking Foot is wonderful for fabrics that stretch or…

  What can go in the Baby Brezza sterilizer?

  The Baby Brezza One Step Sterilizer Dryer automatically sterilizes and dries baby bottles and pump parts in one easy step. This unique appliance uses natural steam to kill 99.9% of germs, then automatically dries. It has a large capacity holding 6 bottles, pump parts and accessories from any brand.

  How long is the sterilization on Baby Brezza?

  The Baby Brezza One Step Sterilizer Dryer removes 99.9% of bacteria and only takes 8 minutes to complete the sterilization process. Bottles remain sterile in the unopened unit for up to 24 hours.